Product ID:EXTERIOR FLAT LATEX, 421-11
MSDS Date:03/01/1994
FSC:8010
NIIN:00N064851
MSDS Number: BZKSP

ASPEN PAINTS

1128 SW SPOKANE ST
SEATTLE, WA 98134
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 206-682-4603

Preparer: D KIER

Cage: 0ALO9

ASPEN PAINTS/ASAMIPEN AMERICA INC

SEATTLE, WA 98134-1187 US

Telephone: 303-573-1014(MED ONLY)

Cage: 0AL09

ETHYLENE GLYCOL (SARA 313) (CERCLA)

CAS: 107-21-1

RTECS: KW2975000

Fraction By Weight: <5%

OSHA PEL N/K

ACGIH TLV: 50 PPM,VAPOR

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

AMMONIUM HYDROXIDE (CERCLA)

CAS: 1336-21-6

RTECS: BQ9625000

Fraction By Weight: <3%

OSHA PEL N/K

ACGIH TLV: N/K

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

179.

RTECS: 9999999VO

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL: ADVERSE HLTH EFTS FROM
VAPS/SPRAY MISTS IN POORLY VENT AREAS MAY INCL IRRIT OF MUC MEMBS
OF NOSE, THROAT & RESP TRACT & SYMPS OF HDCH & NAUS. SKIN/EYE:
PRLNGD/RPTD EXPOSURE TO PRODUCT MAY CAUSE SKIN & EYE IRRIT.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL: MOVE VICTIM AWAY FROM SOURCE OF EXPOSURE AND INTO
FRESH AIR. EYE: PROMPTLY & THORO FLUSH EYES W/WATER FOR AT LEAST 15
MINS & CONSULT MD IF IRRIT PERSISTS. SKIN: REMOVE CONTAMD CLTHG,
WASH SKIN THORO W/SOAP & WATER. WASH CLTHG BEFOREREUSE. INGEST: IF
VICTIM IS CONSCIOUS, GIVE 2 GLASSES OF WATER TO DRINK AND CALL MD.
DO NOT GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.

Flash Point:NONE
Extinguishing Media:PAINT WILL NOT BURN UNTIL WATER HAS EVAPORATED. FOR
RESIDUAL SOLIDS USE DRY CHEMICAL, CO*2, FOAM & WATER FOG.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP.
CLSD CNTNRS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT. USE WATER TO
COOL FIRE EXPOSED CNTNRS. AVOID(SUPDAT)
Unusual Fire/Explosion Hazard:MATL CAN SPLATTER IF TEMP EXCEEDS BOILING
PT. RESIDUAL SOLIDS ARE CAPABLE OF BURNING & GIVING OFF CARBON
MONOXIDE & DIOXIDE. AVOID EXCESS HEAT, OPEN(SUPDAT)

Spill Release Procedures:ELIM ALL IGNIT SOURCES. VENT AREA. IF LGE
SPILL, DIKE AREA TO PVNT MATL FROM ENTERING WATER/SEWER SYSTEM.
RECOVER FREE LIQ, PICKUP REMAINING SPILL W/ABSORB MATL SUCH AS
SAWDUST, SAND/VERMICULITE & PLA CE MATL INTO CLSD CNTNR FOR DISP.
WASH (SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:PROD SHOULD BE STORED AT ROOM TEMP TO
PRLNG STOR LIFE. KEEP FROM FREEZING SO PROD DOES NOT COAGULATE. DO
NOT APPLY WHEN TEMP IS <50F/10C.
Other Precautions:SHAKE OR STIR WELL BEFORE USING. DO NOT TAKE
INTERNALLY. CLOSE CNTNR AFTER EACH USE. KEEP AWAY FROM CHILDREN.
AVOID PRLNGD CONT W/SKIN OR BRTHG OF SPRAY MIST. THESE PRODUCTS
CONTAIN NO MERCURY OR LEAD PIGMENT.

Respiratory Protection:A NIOSH/MSHA APPROVED CANISTER-TYPE RESPIRATOR
MUST BE WORN TO PREVENT THE INHALATION OF VAPORS OR SPRAY MISTS
WHEN TLV PEL IS EXCEEDED.
Ventilation:GENL VENT IS REQD DURING NORMAL USE. LOCAL VENT MAY BE
REQUIRED IN CERTAIN CASES TO KEEP EXPOS LEVEL BELOW LIM LISTED.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGS.
Other Protective Equipment:USE PROT CREAM WHERE SKIN CONT IS LIKELY.
WEAR PROT CLTHG TO PVNT CONT.
Work Hygienic Practices:WASH HANDS BEFORE EATING/USING WASHROOM. SMOKE
IN SMOKING AREA ONLY.
Supplemental Safety and Health
FIRE FIGHT PROC: SPREADING BURNING LIQUID W/WATER USED FOR COOLING
PURPOSES. EXPLO HAZ: FLAMES & ALL IGNIT SOURCES. SPILL PROC: AREA
W/WATER & DETERGENT. NOTIFY APPROP ENVIRON AGENCY(IES) IF SPILL EXC
EEDS 220 LBS.

Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE INGS
Vapor Density:LTR/AIR
Spec Gravity:1.24
pH:SUPDAT
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:DILUTABLE
Appearance and Odor:THICK LIQUID, WHITE & VARIOUS COLORED PAINTS.
Percent Volatiles by Volume:80

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:AVOID HIGH TEMPERATURES, EXCESSIVE HEAT,
OPEN FLAMES AND ALL IGNITION SOURCE.
Hazardous Decomposition Products:WHEN THIS PRODUCT IS HEATED TO DECOMP
IF MAY PRODUCE FUMES WHICH CNTN CARBON MONOXIDE & CARBON DIOXIDE.

Waste Disposal Methods:ALL DISP PROCS MUST COMPLY WITH LOCAL, STATE &
FEDERAL REGULATIONS. REFER TO HAZARD CAUTIONS INFORMATION IN OTHER
SECTIONS OF MSDS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.